Replies Created

  • Stéphane Ory April 14, 2020 at 6:37 pm

    OK… Thanks. I will therefore stick to (and try to improve) the protocol I used.

    Thanks you for your help.

     

    Best.

    Stéphane

    Stéphane Ory April 14, 2020 at 6:18 pm

    Dear Stéphane,

     

    Thank you for your answer. I had forgotten this Ctrl key!! Is there any possibilities to keep the information about the channel used when the selection is done?

    In the mean time, I used the manual counting plugin for detection (1 color for 1 channel) and use ROI colors  to count detection corresponding to a channel. However, it would be easier (and limit mistakes especially when channels used are not necessary the same) if we could keep channel information when the selection is done.

    take care.

    Stéphane

    Stéphane Ory December 20, 2019 at 10:15 am

    Hi Stéphane,

    Thank for your answer. I did not notice it before, but I keep this advice in mind. I just removed the plugin and downloaded it again and it worked.

    Best.

     

    Stéphane